H260 générateur oxygène-hydrogène machine à polir la mode flamme soudeur deau 150L/h

Features:

-2" deep well submersible pump, fits in the 2" well casing.

-Patented impeller design provides extended pump life and heavy flow under the severe circumstances.

-This pump has a much longer pump life than the all-plastic-bottom-suction pump.

This is economical type acrylic flame polishing machine. Its electrolyzer adopts series and parallel compound technique, so electrolysis is

efficientand the powerconsumption of the machine is low.

Theprinciple of operation: Its to extract oxygen and hydrogen through electrolysis of water. Hydrogen as a fuel, oxygencombustion, water

vaporwhich cannotaffect arts and crafts is the only combustionproduct.

Introduction

Oxygen Hydrogen Flame PolisherH260can be used easily, safely, cleanly and effectively with water and electricity as fuel. It is light, energy-saving,

environmental friendly, safeand reliable.

Features

Using a standard electrical supply, hydrogen and oxygen are produced by the electrolysis of distilled water. Inlet AC to electrolytic cell filled with NaOH or

KOH and watermolecules aredecomposed gradually and then hydrogen and oxygen are produced. The mixed gases are passed through a gas atomiser

and delivered to singleor multipletorches viaan output lead.

1. Superiority of Oxygen Hydrogen Flame Polisher

(1) Does not burst

(2) Still and sootless

(3) No carbon comes out

(4) Suitable for indoor work because it is the most clean energy in comparison with any other energies.

2. Economical Efficiency of the mixed Oxygen Hydrogen Gases

Monthly gas cost is cheap, about 1/6 of LPG and about 1/17 of acetylene.

3. Operation Efficiency of Oxygen Hydrogen Flame Polisher

The flame is the pin-pointed with highly pureness and high temperature. It makes a straight on and has a fast flame speed and heat concentration.

4. The machine have two electrolytic tanks and one water filling tank.

Applications

1. Polishing uneven and hard-to-reach area of acrylic products and acrylic parts without any residue, any acrylic lettering
2. Gold, silver, jewelry work
3. Enamel wires lead trimming.
4. For general annealing
5. Solar Panels Manufacture
6. Metal parts partial heat treatment.
7. Ideal for thermocouple processing.

Parameters

Model	H260
Gas Output	150 Liter/Hour
Water Consumption	0.03 Liter/Hour
Working Pressure	<0.2 Mpa
Voltage	220 V /50 Hz; 110 V/ 60 Hz
Dimension (L x W x H)	57 x 30 x 53 (cm)
Weight	15 kg
Accessories
Main Machine	1 pcs
Powerline	1 pcs
Hose	2 pcs
Flame Gun	2 set
Funnel	1 pcs
Operating Manual	1 pcs